Hioki 8730-10 - Saving the Setting Conditions (SET)

151
_____________________________________________________________________________________________
6.4 File Screen
______________________________________________________________________________________________
6.4.2 Saving the Setting conditions (SET)
Command: SETTING
Screen ima
g
ewhenin
p
ut file comment
If a file with the same name already exists,
a warnin
g
messa
g
e will a
pp
ear
NOTE
Saves setting conditions.
Saves all settings except for communications (LAN and RS-232C) and
contrast, and the contents of comparison conditions MODE01 to
MODE16, and comparison areas A01 to A16.
When setting conditions are loaded on the 8730-10, 8731-10, the 8730-10,
8731-10 is set with the loaded setting conditions.
If a settings file is saved with a file comment, the comment will appear at
the top of the screen when the file is loaded (with "
Info (Upper)
" set to
"
Comment
"). (See 4.2.8 for details.)
Procedure
1. Press the
FILE
key, and display the File
screen.
2. Press the left
CURSOR
key to move the
cursor to a command.
3. Select "
SETTING
", then press the
ENTER
key.
4. Enter a filename. For details, see 8. in
3.1.2.
5. To enter a file comment, move the
cursor to the comment field and enter a
comment as described in 4.
6. Press the
START
key to save the data;
press the
STOP
key to cancel.
Starts saving.
Cancels saving
If the amount of data is too large, the data
may not be successfully saved on the PC
card. For details, see 13.3.
It is possible to save without input any file
comment.
If a file with the same name already exists, a
warning message will appear. Rename the
file in step 4 above or save the file by one of
the following two methods:
OVER WRITE : Overwrite the existing file.
NUMBERING : Append a number to the
filename.