Hioki 8730-10 - Horizontal Cursor; Trace Cursor

229
_____________________________________________________________________________________________
10.1 A/B Cursors
______________________________________________________________________________________________
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
10.1.2 Horizontal Cursor
NOTE
When the X-Y screen (see 4.2.4) is selected, the "Y-axis cursor" is used and voltage
on the Y axis is obtained.
10.1.3 Trace Cursor
The scroll bar shows the positions of the A and B cursors.
When only using A cursor:
Obtains the difference in potential [V] based on 0V potential.
When using A and B cursors:
Obtains the difference in potential between A and B (B - A).
Reads the value at a point where the waveform intersects with the A and
B cursors (trace point).
When only using A cursor:
Obtains the timing ("t") from a trigger to the trace point.
Obtains the difference in potential [V] based on 0V potential.
When using A and B cursors:
Obtains the timing ("t") of each of A/B trace points from a trigger.
Obtains the difference in timing between the A and B trace points (B-A).
Obtains the difference in potential [V] of each A/B trace point based on
OV potential.
Obtains the difference in potential between the A and B trace points (B-
A).