Hioki 8730-10 - Voltage Axis Magnification

64
_____________________________________________________________________________________________
4.3 Details of Input Setting
______________________________________________________________________________________________
4.3.4 Voltage Axis Magnification
Setting Screen: Unit CH1 (CH2)
Zoom (X1/2, X1, X2, X5, X10)
NOTE
Magnification and compression of waveform display in the voltage axis
direction can be done.
Waveforms are magnified or compressed using the center of the screen as
a datum point.
Setting Procedure
1. Press the
DISPLAY
key and use the right
and left
CURSOR
keys to select the
"
Unit
"tag.
2. Select the channel to set, then press the
ENTER
key.
(Note 1)
3. Select "
Zoom
", then press the
ENTER
key.
(Note 2)
4. Select a ratio, then press the
ENTER
key.
(Note 1) Channel selection is not possible with the 8730-10.
(Note 2) "Zoom" cannot be selected when the variable function is ON. (See 4.3.9)
The currently selected ratio is shown in red.
If the zero position is not set to 50% at waveform magnification or compression using the center
of the screen as a datum point, the zero position will change when the magnification/compression
rate changes. (See 4.3.5)