65
_____________________________________________________________________________________________
4.3 Details of Input Setting
______________________________________________________________________________________________
4.3.5 Zero Position
Setting Screen: Unit CH1 (CH2)
ZeroPos. (-950% to 1050% max)
Increases in number
Moves the cursor to the right
Decreases in number
How to Change Value for Zero Position
Moves the cursor to the left
Confirms the value
NOTE
Sets the "0V" position.
Moves the screen display position of the waveform up and down. Set the
percentage of screen height where "0V"is to be positioned. The bottom of
the graph is 0%; the top is 100%.
Setting Procedure
1. Press the
DISPLAY
key and use the right
and left
CURSOR
keys to select the
"
Unit
"tag.
2. Select the channel to set, then press the
ENTER
key.
(Note 1)
3. Select "
ZeroPos
." on the menu, then
press the
ENTER
key.
(Note 2)
4. Select a value, then press the
ENTER
key.
(Note 1) Channel selection is not possible
with the 8730-10.
(Note 2) It can not be selected when
variable setting is ON. (See 4.3.9)
The setting range of the zero position varies
depending on the magnification or
compression rate of the voltage axis. For
details, see "Relationship between Zero
Position and Screen Display" on the next
page.
For adjustment of the zero position, see
7.2.1.
To Next Page
Loading...
