Hioki 8730-10 - Flow Control; Delimiter

184
_____________________________________________________________________________________________
7.4 RS-232C
______________________________________________________________________________________________
7.4.5 Flow Control
Setting Screen: RS-232C
Flow Control (OFF, XON-XOFF, Hard)
7.4.6 Delimiter
Setting Screen: RS-232C
Delimiter (CR+LF, LF)
NOTE
Sets the flow control.
Procedure
1. Press the
ADJUST/SYSTEM
key to
display the Adjustment screen.
2. Use the
CURSOR
key to select "
RS232C
"
on "
Page
".
3. Use the
CURSOR
key to select "
Flow
Control", then press the
ENTER
key.
4. Use the
CURSOR
key to select an item,
then press the
ENTER
key.
OFF : No flow control
XON-XOFF : Software handshake
Hard : Hardware handshake
Sets the delimiter for communications commands.
Procedure
1. Press the
ADJUST/SYSTEM
key to
display the Adjustment screen.
2. Use the
CURSOR
key to select "
RS232C
"
on "
Page
".
3. Use the
CURSOR
key to select
"
Delimiter
", then press the
ENTER
key.
4. Use the
CURSOR
key to select "
CR+LF
"
or "
LF
", then press the
ENTER
key.
CR+LF: Sets the delimiter to CR+LF.
LF : Sets the delimiter to LF.
The delimiter setting is common to LAN and RS-232C.