188
_____________________________________________________________________________________________
7.5 External Control Terminals
______________________________________________________________________________________________
7.5.2 EXT_IN
(1) Clear Judge-output
: Clears comparison result output (OK_VALUE, NG_VALUE,
OK_AREA, NG_AREA, or JUDGE_OUT) using EXT_IN
terminal.
(2) Start&Stop
: Controls the starting/stopping of measurement using
EXT_IN terminal. A falling signal starts measurement and
a rising signal stops it.
Setting Screen: EXT-IN, OUT
EXT_IN (Clear Judge-output, Start&Stop)
The multi-function terminal (EXT_IN) is an external control terminal
(input) for which you can select functions.
The following two functions are available:
For the details, See 8.4.5.
Procedure
1. Press the
ADJUST/SYSTEM
key to
display the Adjustment screen.
2. Use the
CURSOR
key to select "
EXT-IN,
OUT"on"
Page
".
3. Use the
CURSOR
key to select "
EXT_IN
",
then press the
ENTER
key.
4. Use the
CURSOR
key to select a input
condition, then press the
ENTER
key.
Clear Judge-output : Clears comparison result
output.
Start&Stop : Controls the start/stop of
measurement with signal
input to the terminal.
To Next Page
Loading...
