Hioki 8730-10 - Editor Command Details

107
_____________________________________________________________________________________________
5.3 Creating Comparison Area
______________________________________________________________________________________________
5.3.3 Editor Command Details
Waveform loaded with "
LastWave
"
Waveform loaded with "
Overlay
"
This section explains the "Editor Commands" used to create a comparison
area.
1. LOAD: Load a measured waveform or area saved in internal memory.
Loads the measured waveform, file, or an area in internal memory.
Execute this command when creating an area based on an acceptable
waveform.
"
CH1
"or"
CH2
", "
FILE (AREA)
", "
FILE (BITMAP)
", or an area from "
A01
"to
"
A16
" may be selected as the source from which to load the data. (CH2 is
available only with the 8731-10.)
When CH1 or CH2 is selected as the load source, choose a type from
"
LastWave
," "
Overlay
," "
Magnify
," and "
AREA
". When a file is selected as
the load source, specify the file name.
Drawing Procedure
1. Use the CURSOR key to select
"LOAD" command, then press the
ENTER key.
2. Use the up and down CURSOR keys
to set the load source.
CH1 : Loads the waveform of CH1.
CH2 : Loads the waveform of CH2
(for the 8731-10 only).
FILE (AREA) : Loads the Area data.
FILE (BITMAP): Loads the Image data.
A01 to A16 : Loads an area from A01 to
A16 from internal memory.
3. When "CH1"or"CH2"isselected,
choose a type in the field on the right.
LastWave : Loads the last waveform
measured.
(For overlaid waveforms, only
the latest waveform is loaded.)
Overlay : Loads the overlaid waveforms.
(This is effective when the
overlay function is ON.)
Magnify : Loads a waveform and
magnifies it in the voltage axis
direction.
(Setting range: -50% to +50%)
AREA : Loads the area currently being
used by this channel.