67
_____________________________________________________________________________________________
4.3 Details of Input Setting
______________________________________________________________________________________________
4.3.6 Color of Wave Display
Setting Screen: Unit CH1 (CH2)
Wave (OFF, RED, GREEN, BLUE, CYAN)
NOTE
4.3.7 Graph of Waveform Display
Setting Screen: Unit CH1 (CH2)
Graph (Graph1, Graph2)
Graph 2
Graph1
NOTE
Specifies the color of wave display.
Waveform display may be turned off.
Even when waveform display is OFF, comparison will be performed.
Setting Procedure
1. Press the
DISPLAY
key and use the right
and left
CURSOR
keys to select the
"
Unit
"tag.
2. Select the channel to set, then press the
ENTER
key.
(Note 1)
3. Select "
Wave
", then press the
ENTER
key.
4. Select "
OFF
" or a color, then press the
ENTER
key.
(Note 1) Channel selection is not possible with the 8730-10.
The currently selected wave display color is shown in red.
When "OFF" is selected, the waveform is not displayed. The comparison area or calculation result
is not displayed either, but comparison is performed. This saves time for display processing and
thus slightly reduces the comparison period.
Selects a graph for displaying a waveform when display format is set to
dual screen (see 4.2.4).
Setting Procedure
1. Press the
DISPLAY
key and use the right
and left
CURSOR
keys to select the "
Unit
"
tag.
2. Select the channel to set, then press the
ENTER
key.
(Note 1)
3. Select "
Graph
", then press the
ENTER
key.
(Note 2)
4.Selectagraph,thenpressthe
ENTER
key.
Graph1: Displays the waveform on Graph 1.
Graph2: Displays the waveform on Graph 2.
(Note 1) Channel selection is not possible with the 8730-10.
(Note 2) This selection is not available when the display format is set to "Single" screen.
To Next Page
Loading...
