Hioki 8730-10 - Measuring

215
_____________________________________________________________________________________________
8.5 Output Terminals
______________________________________________________________________________________________
8.5.7 Measuring <STORAGE Terminal (B11)>
T
STORAGE
START
BUSY
Measurement start
Trigger activated
Measurement sto
p
Operation of
the 8730-10
8731-10
Sto
p
Wait for tri
gg
e
r
Storin
g
waveform
Comparison
p
rocessin
g
Display
p
rocessin
g
Sto
p
Less than 85 ms
Less than 350 ms
Screen u
p
date
W
ait for amplifier signal/
tri
gg
er
Storin
g
waveform
Storing waveform is possible
(Triggering is acceeptable.)
Less than 435 ms
NOTE
The conditions for the above timing example are Single screen format, with no
LAN connection and no A/B cursor display.
Indicates that the 8730-10, 8731-10 is storing a waveform.
The STORAGE terminal (terminal No.: B11) begins to output a low-level
signal (active LOW) when the 8730-10, 8731-10 starts measurement and
updates the screen, and continues signal output until the 8730-10, 8731-10
completes waveform storing.
When STORAGE terminal begins to output LOW signal, triggering is
acceptable.
Output Signal
The STORAGE terminal (B11) outputs a low-level signal (active LOW)
while the 8730-10, 8731-10 is storing a waveform. The terminal is also
set to LOW level while the 8730-10, 8731-10 is waiting for a signal from
the amplifier or a trigger.
<When using an internal power supply>
HIGH level voltage: Max.: 5.5 [V], Min.: 3.5 [V] (When there is no load)
LOW level voltage : Max.: 1.0 [V], Min: 0 [V]
<When using an external power supply>
External power supply voltage V
EXT
: Max.: 30 [V] DC, Min.: 5 [V] DC
HIGH level voltage : Max.: V
EXT
[V], Min.: V
EXT
-1.0 [V] (When there is no load)
LOW level voltage : Max.: 1.0 [V], Min.: 0 [V]
<Timing>