Hioki 8730-10 - Setting Calculation Range

137
_____________________________________________________________________________________________
5.5 Value Comparison Details
______________________________________________________________________________________________
5.5.4 Setting Calculation Range
Setting Screen: Value
Measure Range (All Wave, Part Wave)
Screen with a ran
g
es
p
ecified
Calculations are performed
on data in this ran
g
e
Range-specifying cursor
Moves to the right by
100 samples (1 DIV)
Move to the right by
1 sample (1/100 DIV)
Moves to the left by 100
100 samples (1 DIV)
Specifying select range
Confirm the value
Move to the left by 1 sample (1/100 DIV)
NOTE
Sets a value calculation range.
Value calculations are performed on data in the range between the two
range-specifying cursors.
Setting Procedure
1. Press the
COMP SETTINGS
key, and
select "
Value
"tag.
2. Select"
Measure Range
", then press the
ENTER
key.
(Note 1)
3. Select "
All Wave
"or"
Part Wave
", then
press the
ENTER
key.
All Wave : Performs calculations on all
data.
Part Wave : Performs calculations on data
within the specified range.
When selecting "
Part Wave
"
4. Use the
CURSOR
key to move the range-
specifying cursor to the start point, then
press the
ENTER
key.
5. Use the
CURSOR
key to move the range-
specifying cursor to the end point, then
press the
ENTER
key.
(Note 1) This selection requires that
"
Measurement
"beset"
ON
" under the
"
Value
" tag.
The mark appears at the start point and
end point.
A line is displayed as the range-specifying
cursor is being moved.