Hioki 8730-10 - Area Comparison Details; Area Comparison Setting

122
_____________________________________________________________________________________________
5.4 Area Comparison Details
______________________________________________________________________________________________
5.4.1 Area Comparison Setting
Setting Screen: Area
Comparison
NOTE
5.4 Area Comparison Details
The "
Area
" tag allows you to set various parameters for area comparison.
The setting shall be made separately for each channel (except for the
8730-10).
Area comparison enables the detection of an abnormal waveform that
deviates from the set waveform range. The comparison result (PASS or
FAIL) is output from an external control terminal. (For details of the
external control terminals, see 8.5.2)
Turns area comparison ON/OFF.
Setting Procedure
1. Press the
COMP SETTINGS
key, and
select "
Area
"tag.
2. Select "
Comparison
" on the menu, then
press the
ENTER
key.
3. Select "
OFF
"or"
ON
", then press the
ENTER
key.
OFF : Does not conduct area comparison.
ON : Conducts area comparison.
The currently selected setting condition is shown in red.