Hioki 8730-10 - Internal Power Supply

194
_____________________________________________________________________________________________
8.3 Power Supply Terminal
______________________________________________________________________________________________
8.3.2 Internal Power Supply
External control terminals
Jumper connector
JUDGE
_OFF
ISO_
DCV
HOLD
EXT_
IN
MODE_
SET
MODE0MODE1MODE2MODE3
EXT_
SAMP
EXT_
TRIG
STARTSTOP
EXT_
DCV
EXT_
COM
ISO_
GND
EXT_
OUT1
NG_
VALUE
EXT_
OUT2
EXT_
OUT3
EXT_
OUT4
EXT_
OUT5
STOR
AGE
BUSYERROR
TRIG
_OUT
JUDGE
_OUT
OK_
AREA1
NG_
AREA1
OK_
VALUE
NG_
AREA2
OK_
AREA2
B1 B16B2 B3 B4 B5 B6 B7 B8 B9 B10 B11 B12 B15B14B13
A1 A16A2 A3 A4 A5 A6 A7 A8 A9 A10 A11 A12 A15A14A13
A1-A2
Short-
Circuit
A3-A4
Short-
Circuit
Connection when using an internal power supply
When using an internal power supply
CAUTION
To avoid damage to the 8730-10, 8731-10, do not connect an external power
supply to the 8730-10, 8731-10 when using the built-in power supply.
When using the built-in power supply, connect ISO_DCV terminal (A1) to
EXT_DCV terminal (A2) and EXT_COM terminal (A3) to ISO_GND
terminal (A4).
Use the jumpers supplied to make these connections.
Output voltage is 5V 0.5Vat 40 mA maximum.