Hioki 8730-10 - Page 135

119
_____________________________________________________________________________________________
5.3 Creating Comparison Area
______________________________________________________________________________________________
Screen image before deletion
Screen image deleting
Screen image after deletion
<<Related Issues>>
Press the STOP key to exit the "ERASER"
Press the CURSOR SCROLL key to make the
+ cursor move fast (1 DIV each movement).
Pressing the CURSOR SCROLL key once
again switches modes to low-speed motion (dot-
by-dot movement).
10
20
(X座標, Y座標)
X
coordinate
Y coordinate
9. ERASER: Delete part of the area
Delete part of an area by moving the eraser mark (10 dots wide & 20 dots
long).
Procedure
1. Use the
CURSOR
key to select "
ERASER
"
command, then press the
ENTER
key.
2. The + cursor and the X-Y coordinates
will appear on the screen.
3. Use the
CURSOR
key to move the +
cursor to a section to delete, then press
the
ENTER
key. The cursor will change
to .
4. As the cursor moves, the section where
is located will be deleted.
5. Press the
ENTER
key to confirm the
deleted section.
6. To delete another section, repeat the steps
from 2 to 5 above.
7. To exit the command, press the
STOP
key.
Eraser
The size of the eraser is 10 dots in the X-
axis direction by 20 dots in the Y-axis
direction. The reference point during
deletion is the left corner of the eraser.