Hioki 8730-10 - Page 242

226
_____________________________________________________________________________________________
9.2 RS-232C Interface
______________________________________________________________________________________________
Setting item Preset
Transmission speed 1200 bps to19200 bps
Data Bit 8bit / 7bit
Parity OFF/ODD/EVEN
Stop Bit 1bit / 2bit
Delimiter LF / CR+LF
Flow Control OFF/XON/XOFF/Hard
NOTE
If an overrun or framing error occurs, lower the transmission speed.
Do not edit the setting during communication with the 8730-10, 8731-10.
RS-232C Setting
The controller sends commands for remote control.
To enable communications between the 8730-10, 8731-10 and a PC via the
RS-232C, make the same RS-232C setting for both the 8730-10, 8731-10
and a PC.
For setting details, see 7.4.