246
_____________________________________________________________________________________________
13.1 Error Messages
______________________________________________________________________________________________
Warning 020
Failed to delete the directory.
Check the contents of the directory
Warning 021
File processing is interrupted.
File processing has been interrupted
Warning 022
Shot is too long.
Check the recording length
The maximum recording length that can be read by the
8730-10, 8731-10 is 500 DIV
Warning 031
There is no area.
There is no area for comparison
Create an area
Warning 032
Mode is not registered.
Register a test mode
Warning 033
The Area is specified incorrectly.
Check the comparison area settings (see 5.4.2).
When the comparison area is specified "A- -", the area
data is cleard by turning power off. Resister a settings &
area file (See 6.4.5) again, or select an area from "A01 to
A16".
Warning 040
Range-over.
Select a correct voltage axis range
See 7.5.3
Warning 041
The variable is ON.
The display will not change.
The waveform display does not change
Because the variable function is ON, waveform display will
not change even when the range is changed.
Check the setting of the variable function
Warning 042
The setting range is exceeded.
Enter a value within the setting range
Warning 044
The Upper and Lower are inappropriate.
Check the settings
Warning 045
The Using Area is inappropriate.
Check the comparison area
Warning 046
Calculations are not available.
Calculations and averaging cannot be performed
simultaneously
Warning 050
The loading operation failed. The setting
conditions contain an error.
Loading of settings failed.
Check the setting conditions for the main unit.
Warning 090
Illegal MAC address.
The MAC address is incorrect
The 8730-10, 8731-10 requires repair
Warning 091
Illegal IP address.
Correct the IP address setting
Warning 092
Illegal server IP address.
Check the server IP address
Warning 093
Failed to connect with the server.
Check the LAN setting and connection
Warning 094
Failed to connect with the 9333.
Check the settings on the 9333 and connection
Warning 095
LAN timeout.
Check the PC to which the 8730-10, 8731-10 is connected
Warning 096
LAN transmission has been interrupted
Check the PC to which the 8730-10, 8731-10 is connected
Warning 097
Network error.
Check the PC to which the 8730-10, 8731-10 is connected
Warning 098
Server cannot be found.
Check the PC to which the 8730-10, 8731-10 is connected
Warning 099
DHCP failed.
Check to see if DHCP server operates properly on the
network
To Next Page
Loading...
