Hioki 8730-10 - Page 5

Chapter 5 Comparison and Calculation 93
5.1 Overview 96
5.2 Comparison Details
97
5.2.1 Common Stop Condition 97
5.2.2 Screen Updating 99
5.2.3 Switching Test Modes 99
5.2.4 Registering Test Modes 100
5.2.5 Clearing Test Modes 101
5.2.6 Setting the Beep sound for PASS decisions 101
5.2.7 Setting the Beep sound for FAIL decisions 102
5.2.8 Re-compare 102
5.3 Creating Comparison Area 103
5.3.1 Area Comparison Sequence 103
5.3.2 Creating Area 105
5.3.3 Editor Command Details 107
5.4 Area Comparison Details 122
5.4.1 Area Comparison Setting 122
5.4.2 Area Comparison Conditions 123
5.4.3 Stop Conditions of Area Comparison 125
5.5 Value Comparison Details 126
5.5.1 Flow of Setting Value Comparison and
Measurement 126
5.5.2 Value Comparison 127
5.5.3 Value Calculations 127
5.5.4 Setting Calculation Range 137
5.5.5 Stop Conditions of the Value Comparison 138
5.5.6 Display of value calculation results 139
5.6 Waveform Calculation 140
5.6.1 Setting the Waveform Calculation 140
5.6.2 Setting Type of Calculation 141
5.6.3 Re-calculation 142
5.7 List 143
Chapter 6 Saving and Loading Data 145
6.1 Overview 146
6.2 PC Card
146
6.3 Saveable Data
148