Hioki 8730-10 - Page 7

7.4 RS-232C 182
7.4.1 Transmission Speed 182
7.4.2 Data Bit 182
7.4.3 Parity 183
7.4.4 Stop Bit 183
7.4.5 Flow Control 184
7.4.6 Delimiter 184
7.5 External Control Terminals 185
7.5.1 EXT_OUT1 to EXT_OUT5 186
7.5.2 EXT_IN 188
7.5.3 Range-over Detection 189
Chapter 8 External Control Terminals 191
8.1 Overview 191
8.2 Terminals
192
8.3 Power Supply Terminal
193
8.3.1 External Power Supply 193
8.3.2 Internal Power Supply 194
8.4 Input Terminals 195
8.4.1 Start/Stop Measurement 196
8.4.2 External Trigger 197
8.4.3 External Sampling 198
8.4.4 Selecting a Test Mode 199
8.4.5 Multi-function terminal (Input) 201
8.4.6 Holding Comparison Results 202
8.4.7 Canceling Output of Comparison Result 203
8.5 Output Terminals 204
8.5.1 Output of Value Comparison Results 205
8.5.2 Output of Area Comparison Results 208
8.5.3 Comparison Result Being Output 212
8.5.4 Trigger Output 213
8.5.5 Error Signals Output 213
8.5.6 Processing 214
8.5.7 Measuring 215
8.5.8 Multi-Function Terminals (Output) 216
8.6 Example of Control via the External Control
Terminals 217
8.7 External Control Connection Example
218
Chapter 9 Interface 219
9.1 LAN Interface 220
9.2 RS-232C Interface
225