Hiwin E1 Series - Delete selected parameter

Servo Drive Configuration E1 Series Servo Drive Thunder Software Operation Manual
4-54 HIWIN MIKROSYSTEM CORP.
MD12UE01-2012
◼ Delete selected parameter
1. Check the parameter to be deleted.
Figure 4.4.2.3.5
Information
Users can check the box on the left side of Parameter Name to select all the parameters with
one click.
Figure 4.4.2.3.6
2. Click “Delete selected parameter” icon.
Figure 4.4.2.3.7
3. A message window that the parameter is successfully deleted will pop up. Click OK.
Figure 4.4.2.3.8