Hiwin E1 Series - 4.5.4 Check configuration of IO signals

Servo Drive Configuration E1 Series Servo Drive Thunder Software Operation Manual
4-78 HIWIN MIKROSYSTEM CORP.
MD12UE01-2012
4.5.4 Check configuration of I/O signals
Users can check the configuration of all I/O signals on each pin of CN6 here. If a single pin is assigned to
several digital output signals, click to see all signals assigned to it.
Figure 4.5.4.1
Information
The following figure shows the pin assignment of Fieldbus servo drive.
Figure 4.5.4.2