E1 Series Servo Drive Thunder Software Operation Manual Advanced Functions
HIWIN MIKROSYSTEM CORP. 9-15
9.2.8 Clear multi-motion parameters and disable multi-motion function
Clear the multi-motion parameters saved in servo drive and disable multi-motion function.
1. Click “Clear data” icon .
Figure 9.2.8.1
2. Read the message window and click Yes. At this time, the servo drive will be power cycled.
Figure 9.2.8.2
3. After the servo drive is power cycled, “Disable multi-motion function success!” window will pop up.
After users click OK, the multi-motion parameters saved in servo drive will be successfully cleared
and multi-motion function will be disabled.
Figure 9.2.8.3
To Next Page
Loading...
