96
z Baud rate: Select baud rate.
z Data bit: Select data bit.
z Stop bit: Select stop bit.
z Parity: There are three choices: none/odd/even.
After completed all the setups please click save button, system goes
back to the previous menu.
For detailed setup, please refer to chapter 4.9 preset/patrol/pattern/scan.
Figure 5-24 PTZ Setup Menu
Display
Display setup interface is shown as below. See 768HFigure 5-25.
z Transparency: Here is for you to adjust transparency. The value ranges
from 128 to 255.
z Channel name: Here is for you to modify channel name. System max
support 25-digit (The value may vary due to different series). Please
note all your modification here only applies to DVR local end. You need
to open web or client end to refresh channel name.
To Next Page
Loading...
