166
Alarm Centre
Alarm centre interface is shown as below. See Figure 7-37.
This interface is for you to develop. The alarm signal can be uploaded
to the alarm centre when there is local alarm.
Please set the corresponding parameters such as server IP, port and
etc.
The system can send out the data as the protocol defined to the client-
end.
Figure 7- 36 Alarm Setup Menu
Advanced
The advanced interface is shown as in Figure 7-38.
z
Multiple cast
Please refer to chapter 5.3.5.3 for detailed multiple cast setup
information.
z
PPPoE
Please input the PPPoE user name and password you get from the IPS
(internet service provider) and enable PPPoE function. Please save
current setup and then reboot the device to get the setup activated.
To Next Page
Loading...
Need help?
General