51
z Show message: System can pop up a message to alarm you in the
local host screen if you enabled this function.
z Alarm upload: System can upload the alarm signal to the network
(including alarm centre) if you enabled current function.
z Send email: System can send out email to alert you when alarm
occurs.
z PTZ activation: Here you can set PTZ movement when alarm
occurs. Such as go to preset, tour &pattern when there is an alarm.
Click “select” button, you can see an interface is shown as in
698HFigure
4-22
.
z Period: Click set button, you can see an interface is shown as in
699HFigure 4-23. Here you can set for business day and non-business
day. In
700HFigure 4-23 click set button, you can see an interface is
shown as in
701HFigure 4-24. Here you can set your own setup for
business day and non-business day.
z Anti-dither: Here you can set anti-dither time.
z Alarm output: when alarm occurred, system enables peripheral
alarm devices.
z Tour: Here you can enable tour function when alarm occurs.
System one-window tour. Please go to chapter 5.3.9 Display for
tour interval setup.
z Snapshot: You can enable this function to snapshoot image when
alarm occurs.
Please highlight icon
to select the corresponding function. After
all the setups please click save button, system goes back to the
previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel
setup since the video in each channel may not be the same.
In
702HFigure 4-21, you can left click mouse and then drag it to set a
region for motion detection. Click Fn to switch between arm/withdraw
motion detection. After setting, click enter button to exit.
To Next Page
Loading...
Need help?
General