Main Tab
Start > Settings > Control Panel > Data Collection > Main tab
The parameters shown on these panels are only those that apply to the specific mobile device.
Device with any other scan engine Device with Hand Held Products Imager
Note: The Scan Mode (Continuous Scan) section is only present if the MX7 Tecton has a Honeywell or Symbol integrated
scanner.
Parameter Function
Device 1,2,3
1 - Default is Disabled
2 - Default is Internal
3 - Default is Disabled
The data collection device (laser scanner, laser imager, internal, external, or wireless).
Keep Awake Default is Disabled.
Scan Mode
Default is Disabled. This box is only shown when the internal scanner is a Symbol scanner. See
Continuous Scan Mode below for an explanation.
Send Key Messages
(WEDGE)
Default: Enabled.
When Send Key Messages (WEDGE) is checked any data collection scan is converted to
keystrokes and sent to the active window. When this checkbox is not checked, the application will
need to use the set of Scanner APIs to retrieve the data from the scanner driver. Note that this latter
method is significantly faster than using Wedge.
4-83
To Next Page
Loading...
