LEAP
To use LEAP (without WPA), make sure the following profile options are used.
l Enter the SSID of the Access Point assigned to this profile
l Set EAP Type to LEAP
l Set Encryption to WEP EAP or Auto WEP (depending on SCU version)
l Set Auth Type as follows:
l If the Cisco/CCX certified AP is configured for open authentication, set the Auth Type radio parameter to
Open.
l If the AP is configured to use shared key or passphrase, set the Auth Type radio parameter to Shared.
l If the AP is configured for network EAP only, set the Auth Type radio parameter to LEAP.
See Sign-On vs. Stored Credentials for information on entering credentials.
8-25
To Next Page
Loading...
