Update Help
The powered device won't boot up after update is finished.
Send the MX7 Tecton to Honeywell for re-imaging.
Warning: Opening the device e.g. removing endcaps or access panels, etc. could void the user's authority to operate this
equipment.
Battery State and OS Upgrade
A fully charged main battery should be installed in the MX7 Tecton prior to upgrading the operating system. A prompt may
appear when the battery reaches Critical Low that informs the user there is not enough power in the main battery to perform the
update.
The operating system will not be able to execute the OS update when the battery level is too low (25% or less), as there is a
high risk that the power remaining in the battery expires when executing the update and the MX7 Tecton will be left in an
inoperable state.
When main battery power level is too low, connect external power to the MX7 Tecton before performing the update procedure.
Do not disconnect external power before the update process is complete.
4-24
To Next Page
Loading...
