Wavelink Avalanche Enabler (Optional)
Note: If the user is NOT using Wavelink Avalanche to manage their mobile device, the Enabler should not be installed on the
mobile device(s).
The following features are supported by the Wavelink Avalanche Enabler when used in conjunction with the Avalanche
Manager.
After configuration, Enabler files are installed upon initial bootup and after a hard reset. Network parameter configuration is
supported for:
l IP address: DHCP or static IP
l RF network SSID
l DNS hosts (primary, secondary, tertiary)
l Subnet mask
l Enabler update
Related Manual: Using Wavelink Avalanche on Windows Computers
The MX7 Tecton has the Avalanche Enabler installation files loaded, but not installed, on the mobile device when it is shipped.
The installation files are located in the System folder on CE devices. The installation application must be run manually the first
time Avalanche is used.
After the installation application is manually run, a reboot is necessary for the Enabler to begin normal performance. Following
reboot, the Enabler will by default be an auto-launch application. This behavior can be modified by accessing the Avalanche
Update Settings panel through the Enabler Interface.
Internet Explorer
Start > Programs > Internet Explorer
This option requires a radio card and an Internet Service Provider. There are a few changes in the Windows CE version of
Internet Explorer as it relates to the general desktop Windows PC Internet Explorer options. Tap the “?” button to access
Internet Explorer Help.
4-13
To Next Page
Loading...
Need help?
General
Weight and Dimensions
