Custom Parameter Option
The parameter Custom option is not supported. The parameter value is displayed as “Custom” when the operating system
registry has been edited to set the Summit parameter to a value that is not available from the parameter’s drop down list.
Selecting Custom from the drop down list has no effect. Selecting any other value from the drop down list will overwrite the
“custom” value in the registry.
Global Parameters
Parameter Default Function
Roam Trigger -65 dBm
If signal strength is less than this trigger value, the client looks for a different
Access Point with a stronger signal.
Options are: -50 dBm, -55, -60, -65, -70, -75, -80, -85, -90 dBm or Custom.
Note: Available options may vary by SCU revision.
Roam Delta 5 dBm
The amount by which a different Access Point signal strength must exceed the
current Access Point signal strength before roaming to the different Access
Point is attempted.
Options are: 5 dBm, 10, 15, 20, 25, 30, 35 dBm or Custom.
Roam Period 10 sec.
The amount of time, after association or a roam scan with no roam, that the
radio collects Received Signal Strength Indication (RSSI) scan data before a
roaming decision is made.
Options are: 5 sec, 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 seconds or
Custom.
8-15
To Next Page
Loading...
