Notification Tab
Start > Settings > Control Panel > Data Collection > Notification tab
Internal Scanner Sound
This panel toggles internal scanner sounds on and off. Internal scanner sound, by default, is on (enabled).
Vibration
Vibration on the MX7 Tecton is activated when a scan is completed successfully or with a failure (scan key released before
good scan, timeout, or rejected because of Data Options configuration). It is not activated when a trigger or scan key is
pressed. The default setting for both Good Scan and Bad Scan vibration is Off.
Enable this parameter when a tactile response on a good scan or bad scan is desired. Scan sounds are accompanied by a
tactile response when the internal scanner Sound parameter is enabled. Enable short, medium or long duration for each
selection (good scan and bad scan).
4-86
To Next Page
Loading...
