Bluetooth taskbar Icon state and Bluetooth device Icon states change as Bluetooth devices are discovered, paired, connected
and disconnected. There may be audible or visual signals as paired devices re-connect with the MX7 Tecton.
l The default Bluetooth setting is On.
l The MX7 Tecton cannot be discovered by other Bluetooth devices when the Computer is discoverable option is
disabled (unchecked) on the Settings panel.
l Other Bluetooth devices cannot be discovered if they have been set up to be Non-Discoverable or Invisible.
l When Filtered Mode is enabled, the MX7 Tecton can pair with one Bluetooth scanner and one Bluetooth printer.
l When Filtered Mode is disabled, the MX7 Tecton can pair with up to four Bluetooth devices.
l It is not necessary to disconnect a paired scanner and printer before a different scanner or printer is paired with the MX7
Tecton.
l The target Bluetooth device should be as close as possible (up to 32.8 ft (10 meters) Line of Sight) to the MX7 Tecton
during the pairing process.
Assumption: The System Administrator has Discovered and Paired targeted Bluetooth devices for the MX7 Tecton. The MX7
Tecton operating system has been upgraded to the revision level required for Bluetooth client operation. An application (or API)
is available that will accept data from serial Bluetooth devices.
4-58