Honeywell SmartLine SLG 700 - Page 12

Page xii SLG 700 SmartLine Level Transmitter User’s Manual Revision 8
Figure 3-15 Saturated steam application rod probe assembly ............................................................ 60
Figure 3-16: Saturated steam application coaxial probe assembly ..................................................... 60
Figure 3-17: Recommended location of holes for rod probes .............................................................. 63
Figure 3-18: Centering disks for wire and rod probes. ......................................................................... 64
Figure 3-19: Centering disks for FEP coated wire and rod probes ...................................................... 64
Figure 3-20: Probe length definition for rod probes using a centering disk ......................................... 67
Figure 3-21: Flanged SLG720 Transmitter, mm [in] ............................................................................ 67
Figure 3-22: Threaded (NPT ¾", 1", 1½", 2") SLG720 Transmitter, mm [in] ....................................... 68
Figure 3-23: Threaded (BSP/G ¾”, 1”, 1½”) SLG720 Transmitter, mm [in] ......................................... 69
Figure 3-24: Flanged SLG726 transmitter, mm [in] ............................................................................. 70
Figure 3-25: Threaded (NPT 1½", 2”) SLG726 transmitter, mm [in] .................................................... 71
Figure 3-26: Threaded (BSP/G 1½") SLG726 transmitter, mm [in] ..................................................... 72
Figure 3-27: Mounting position ............................................................................................................ 73
Figure 3-28: SLG720 temperature limits .............................................................................................. 75
Figure 3-29: SLG726 temperature limits .............................................................................................. 76
Figure 3-30: SLG726 Maximum pressure based on maximum operating temperature....................... 76
Figure 3-31: Flanged tank connection ................................................................................................. 78
Figure 3-32: Flange mounting .............................................................................................................. 79
Figure 3-33: Oversized nozzle configuration ....................................................................................... 80
Figure 3-34: Threaded tank connection ............................................................................................... 81
Figure 3-35: Tank roof mounting using threaded connection .............................................................. 81
Figure 3-36: Bypass installation ........................................................................................................... 82
Figure 3-37: Mounting on a non-metallic vessel .................................................................................. 83
Figure 3-38: Mounting in concrete silos ............................................................................................... 84
Figure 3-39: Remote mount ................................................................................................................. 85
Figure 3-40: Rotate transmitter housing .............................................................................................. 86
Figure 3-41: Anchoring wire probes ..................................................................................................... 87
Figure 3-42: Wire probe slack .............................................................................................................. 87
Figure 3-43: Anchoring coaxial probes ................................................................................................ 88
Figure 3-44: Transmitter operating ranges .......................................................................................... 91
Figure 3-45: HART 3-Screw Terminal Board and Grounding Screw ................................................... 93
Figure 4-1: Three-Button Option .......................................................................................................... 98
Figure 4-2: Advanced Display Formats with the Process Variable .................................................... 120
Figure 4-3: Locating the Failsafe and Write Protect Jumpers ............................................................ 124
Figure 5-1: Current Loop Test Connections ....................................................................................... 130
Figure 5-2: Electronic Housing Components ..................................................................................... 131
Figure 5-3: Sensor Housing ............................................................................................................... 132
Figure 5-45-5: Part Number and Date Code (D/C) label on bottom of Terminal PCBA assembly .... 134
Figure 5-6: Location of sensor housing and attachment set screws ................................................. 135
Figure 5-7: Communications Housing Assembly ............................................................................... 136