Honeywell SmartLine SLG 700 User Manual

Page 62 SLG 700 SmartLine Level Transmitter User’s Manual Revision 8
Note:
SLG720: One 3.5mm hole to be drilled into the end of the rod probe using
a supplied drilling jig once the probe has been cut to length (if required).
 SLG720 PTFE application: No hole required.
See Error! Reference source not found..
SLG726: Require two 3.5mm holes.
See
Figure 3-17: Recommended location of holes for rod
probesand Figure 3-18: Centering disks for wire and rod
probesfor recommended location of holes and assembly
details of the centering disk. Secure the cotter pin by bending
the leads back once installed. See
Table 3-12 and Table 3-13 for details.

Honeywell SmartLine SLG 700 Specifications

General

Brand	Honeywell
Model	SmartLine SLG 700
Category	Transmitter
Language	English