EasyManuals Logo

Honeywell UMC800 Reference Guide

Honeywell UMC800
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #214 background imageLoading...
Page #214 background image
Function Blocks
Function Block Reference Guide 3/99204
2.69 SYNC Function Block
Description
The
SYNC
label stands for
Synchronize
.
This block is part of the
Setpoint Program
category. It looks like
this graphically on the Control Builder.
Function
Used to synchronize the operation of two setpoint programs given the run. Hold and reset signals from each
program.
Input (available for Logic control of programmer)
RST = RESET command, when turned ON.
HLD = HOLD command, when turned ON.
RUN = RUN command, when turned ON.
ADV = ADVANCE command, when turned ON
Output
The status of each programmer connected to the output pins of the block are monitored. A change in state of
any of the programmers is transferred to the other programmers. This occurs regardless of input pin
connections. Use of block inputs is optional.
Note: Ghold status is not transferred between programmers with this block.
Block Properties
Double click on the function block to access the function block properties dialog box.
Block Order (Read Only)
You can change the assigned execution order number by selecting “Execution Order” in the “Configure”
menu and arrange the order to suit your control strategy.

Table of Contents

Other manuals for Honeywell UMC800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell UMC800 and is the answer not in the manual?

Honeywell UMC800 Specifications

General IconGeneral
BrandHoneywell
ModelUMC800
CategoryController
LanguageEnglish

Related product manuals