Honeywell UMC800 Reference Guide

Function Blocks
Function Block Reference Guide 3/9982
2.27 HMON Function Block
Description
The
HMON
label stands for
High Monitor
. This block is part of the
Alarm/Monitor
category. It looks like
this graphically on the Control Builder.
Function
Monitors two analog input values (X and Y) and turns ON a digital output if X exceeds Y.
A hysteresis adjustment is provided to prevent output cycling.
• If X > Y, then
OUT = ON.
• If X < or = (Y – Hysteresis), then
OUT = OFF.
• If (Y – Hysteresis) < X < Y, then
OUT = Previous State.
Input
X
= Analog value
.
Y
= Analog value
Output
OUT = Digital signal
Block Properties
Double click on the function block to access the
function block properties dialog box.
Block Order (Read Only)
You can change the assigned execution order
number by selecting “Execution Order” in the
“Configure” menu and arrange the order to suit
your control strategy.
Configuration Parameters
You must configure the HMON function Block
parameters to the desired value or selection that
matches your operating requirements.
Table 2-26
describes the parameters and the
value or selection.
Continued next page

Honeywell UMC800 Specifications

General

Brand	Honeywell
Model	UMC800
Category	Controller
Language	English