Honeywell UMC800 Reference Guide

Function Blocks
3/99 Function Block Reference Guide 73
2.23 FGEN Function Block,
continued
Configuration Parameters
Block Properties
Double click on the function block to access the
function block properties dialog box.
Block Order (Read Only)
You can change the assigned execution order
number by selecting “Execution Order” in the
“Configure” menu and arrange the order to suit
your control strategy.
Configuration Parameters
You must configure the FGEN function Block
parameters to the desired value or selection that
matches your operating requirements.
Table 2-22
describes the parameters and the
value or selection
.
Continued next page

Honeywell UMC800 Specifications

General

Brand	Honeywell
Model	UMC800
Category	Controller
Language	English