Chapter 5
Utilities
Management Processor Command Interface
109
Management Processor Command Interface
Use the management processor menus and commands as needed. The login screen, which includes the Main Menu, is shown
below. Main Menu commands (CO, VFP, CM, CL, CSP, SE, SL, HE, and X) can be entered after the MP prompt. Commands not
displayed in the MP Main Menu can be accessed in command mode by first using the CM command at the MP prompt. (A list of
available commands can be displayed by using the management processor help function. Display the list of commands as
follows: in the MP Main Menu, enter HE after the MP> prompt, then enter LI after the MP HELP: prompt.) You can return to
the MP Main Menu by typing
CTRL+B.
Figure 5-2 MP Welcome Screen
MP Login: Admin
MP password: *****
Hewlett-Packard Management Processor
(C) Copyright Hewlett-Packard Company 1999-2003. All rights reserved
System Name: xxxxxxxxx
MP MAIN MENU:
CO:Console
VFP:Virtual Front Panel
CM:Command Menu
CL:Console Log
SL:Show Event Logs
CSP:Connect to Service Processor
MP commands are described in the following paragraphs.
To Next Page
Loading...
