Chapter 4
Installing Additional Components and Configuring
Converting SCSI From Simplex to Duplex
68
• Plug the SCSI cable B connector into the SCSI connector located on the backplane next to the duplex board
installed in the previous step.
Figure 4-20Installing SCSI Cable B to the SCSI Backplane
Step 4. The SCSI duplex conversion is completed by connecting the other end of SCSI cable B to the SCSI B channel
connector on the SCSI adapter board. See Figure 4-21, “Installing SCSI Cable B to the SCSI Adapter Board.”
• Release the SCSI B cable from its stowed position within the chassis.
To Next Page
Loading...
