Chapter 4
Installing Additional Components and Configuring
Core I/O Connections
75
Step 10. A new lc listing is displayed, including the values entered in the preceding steps. Verify that the desired values
have been accepted. When prompted to enter a parameter for revision, Y to confirm, or Q to Quit, enter Y to
confirm all parameters.
Step 11. Observe the following display:
> LAN Configuration has been updated
-> Reset MP (XD command option ‘R’) for configuration to take effect.
MP Host Name: name
(the name entered in step 5)
MP:CM>
Step 12. Enter XD -reset to reset the MP.
Step 13. After the MP resets, log into the MP again. Then enter the MP command mode (enter CM at the MP: prompt).
Step 14. At the MP:CM> prompt, enter LS to confirm the new LAN settings.
Step 15. Enter SA to enable/disable web console and telnet access after the MP has been reset.
Figure 4-23The LC Command Screen
MP:CM> lc -ip 127.0.0.1 -host uninitialized -mask 255.255.255.0 -gate 127.0.0.1 -web 2003
New LAN Configuration (* modified value):
* IP Address: 127.0.0.1
* MP Host Name: uninitialized
* Subnet Mask: 255.255.255.0
* Gateway Address: 127.0.0.1
Link State: Auto Negotiate
* Web Console Port Number: 2023
Confirm? (Y/ {N}) : y
-> LAN configuration has been updated
-> Reset the MP (XD command option ‘R’ ) for confirmation to take effect.
MP Host Name : uninitialized
MP:CM> xd -reset
Management Processor Commands
Table 4-8 Management Processor Commands and Descriptions
Command Description
BP Reset BMC passwords
To Next Page
Loading...
Need help?
General