Chapter 7
141
7 Removing and Replacing Components
Safety Information
Follow the procedures listed below to ensure safe handling of components and to prevent harm to both you and the HP Server:
• Use an antistatic wrist strap and a grounding mat, such as those included in the Electrically Conductive Field Service
Grounding Kit (HP 9300-1155).
• Handle accessory boards and components by the edges only. Do not touch any metal-edge connectors or any electrical
components on accessory boards.
• Do not wear clothing subject to static charge build-up, such as wool or synthetic materials.
WARNING Hazardous voltages are present inside the HP Server. Always remove AC power from the server
and associated assemblies while working inside the unit. Serious injury may result if this warning is
not observed.
Service Tools Required
Service of this product may require one or more of the following tools:
• Electrically Conductive Field Service Kit (P/N 9300-1155)
• 1/4 inch Flat Blade Screwdriver
• ACX-15 torx Screwdriver
Accessing a Rack Mounted Server
The hp Integrity rx4640 Server is designed to be rack mounted. The following procedure explains how to gain access to your
hp Integrity rx4640 Server that is mounted in an approved rack. For rack installation instructions, review the document titled
Installation Guide, Mid-Weight Slide Kit, 5065-7291. This document can be accessed at: http://www.hp.com/racksolutions.
WARNING Ensure that all anti-tip features (front and rear anti-tip feet installed; adequate ballast properly placed;
and so on) are employed prior to extending the server.
Extend the Server from the Rack
NOTE Ensure that there is enough area (Approximately 1.5 meters [4.5 ft.]) to fully extend the server out the front
and work on it.
To Next Page
Loading...
Need help?
General