Chapter 7
Removing and Replacing Components
Display Board
217
Removing the Display Board
To remove the display board, perform the following steps:
Step 1. If rack mounted, slide the HP Server out from the rack until it stops. See “Accessing a Rack Mounted Server” on
page 141.
Step 2. Remove the front bezel. See “Front Bezel” on page 144.
Step 3. Remove the front cover. See “Front and Top Covers” on page 145.
Step 4. Using your finger, slightly pull out the retaining tab on the chassis that holds the display board in position.
Step 5. Gently unplug the midplane riser board connector cable from the display board and remove the board from the
chassis.
Replacing the Display Board
To replace the display board, perform the following steps:
Step 1. Gently plug in the midplane riser board cable into the display board.
Step 2. Hold the display board in position near the chassis and rotate it into the retaining clip until it clicks into place.
Step 3. Replace the front cover.
Step 4. Replace the front bezel.
Step 5. If rack mounted, slide the HP Server into the rack until it stops.
To Next Page
Loading...
Need help?
General