Chapter 4
Installing Additional Components and Configuring
Installing Power Supplies and Disk Drives
38
Figure 4-3 Metal Cover in Unused P 1 Slot
Installing Hot-Plug Disk Drives
One additional hot-plug disk drive may be added to your hp Integrity rx4640 Server in slot 2. Always use low profile disk
drives (1.0" height) in your HP Server.
To install a hot-plug disk drive, perform the following steps:
Step 1. Slide the hot-plug hard disk into slot 1 until it is seated.
Step 2. Close the drive-ejector handle by pushing it down until it clicks.
To Next Page
Loading...
