Chapter 5
Utilities
Management Processor Command Interface
116
Power Status
PS: Power status—display the status of the power management module
This command displays on the console the status of the power management module.
Reset BMC
RB: Reset BMC
This command resets the BMC by toggling a GPIO pin.
Reset System
RS: Reset system through RST signal
IMPORTANT Under normal operation, shut down the OS before issuing this command.
This command causes the system (except the MP) to be reset through the RST signal.
Execution of this command irrecoverably halts all system processing and I/O activity and restarts the computer system. The
effect of this command is very similar to cycling the system power. The OS is not notified, no dump is taken on the way down,
and so on.
Set Access
SA: Set access options—configures access for LAN and remote/modem ports
This command will disconnect modem, LAN, and web users if access is disabled.
Create Local Session
SE: Log into the system on local or remote port
Only valid from the local or remote/modem port, SE allows the user to leave the MP Command Interface and enter a system
session. Other mirrored MP users are placed in console mode. The session user returns to the mirrored MP session on exit.
The MP regularly checks the activity of the session, closes the connection with the system, and, if the timeout period has
elapsed, returns the port to mirroring. The timeout period is set with the IT command. On HP-UX, the SE command works on
the local and remote ports.
In HP-UX, use the System Administration Manager (SAM) to add modem device files for the session UARTS. The modem
type, CCITT or Bell must agree with the remote port settings for the remote session port and always be Bell mode for the local
session port.
If the system and the MP Command Interface local or remote ports have been configured with different port speeds, the baud
rate changes to the rate specified by the OS for the duration of the session.
Display Logs
SL: Display contents of the system status logs
This command displays the contents of the event logs that have been stored in nonvolatile memory.
• System Event Log (SEL)—High attention events and errors
• Forward progress—All events
To Next Page
Loading...
Need help?
General