Chapter 5
Utilities
Management Processor Command Interface
118
Firmware Revision Status
SYSREV: Displays the revision status of firmware in the system processors
This command displays the revision status of firmware in the system processors.
System Status
SS: Displays the status of the system processors
The SS command displays the status of the system processors and which processor is the monarch.
Transfer Of Control
TC: System reset through INIT or TOC (Transfer of Control) signal
Under normal operation, shut down the OS before issuing this command.
This command causes the system to be reset through the INIT (or TOC) signal. Execution of this command irrecoverably halts
all system processing and I/O activity and restarts the computer system. It is different from the RS command in that the
processors are signaled to dump state on the way down.
Tell
TE: TEll—sends a message to other terminals
Up to 80 characters can be typed in. The message is broadcast to the other mirrored clients. Users in a session or CSP are not
shown the message.
User Configuration
UC: User Configuration—controls user access
This command allows an administrator to add, modify, re-enable, or delete user logins. The administrator can also enable or
disable security warnings and change passwords.
Virtual Front Panel
VFP: Display Virtual Front Panel
When invoked, this command displays a current summary of system status, including the state of front panel LEDs.
There are two ways that the live display of events can be started:
1. Live Mode: Invoked from the VFP command at the MP prompt. To exit, type Q to quit the console.
2. Early Boot Mode: When the boot sequence for the system begins, the live VFP is invoked automatically. When boot
finishes, you are automatically switched to console mode.
The LWED state reflects the state of the front panel LEDs. When system power is off, the remote LED shows “off” even
thought remote access may be enabled with the EL or ER commands.
Who
WHO: Displays a list of MP connected users
To Next Page
Loading...
Need help?
General