Chapter 4
Installing Additional Components and Configuring
Installing Processors and Memory
51
Removing a Memory Extender Board
To remove a memory extender board, perform the following steps:
Step 1. If rack mounted, slide the HP Server out from the rack until it stops. See “Accessing a Rack Mounted Server” on
page 141.
Step 2. Remove the front bezel from the chassis. See “Front Bezel” on page 144.
Step 3. Remove the front cover from the chassis. See “Removing the Front Cover” on page 145.
Step 4. Press each latch on the two extraction levers located on each side of the memory extender board.
Step 5. Pull on the extraction levers to unplug the memory extender board from the socket located on the midplane riser
board and remove the memory extender board from the chassis.
Installing DIMMs
To install DIMMs, perform the following steps:
Step 1. Align the DIMM with the socket located on the memory extender board.
Step 2. Gently and evenly push on each side of the DIMM until it seats in the socket. Ensure that the extraction levers are
in the closed position.
Step 3. Replace the front and top covers.
Step 4. Replace the front bezel.
To Next Page
Loading...
Need help?
General