Chapter 4
Installing Additional Components and Configuring
Hot-Plug PCI-X
64
2. Hardware Operation Fault
If the PCI-X card cannot be powered on during a hot-plug addition operation, the attention LED will turn steady-on and
the power LED will go steady-off.
CAUTION If your card will not power up, the power loss may be due to the existing PCI-X expansion cards using all
the available power. Check the power ratings of your existing PCI-X cards. A known cause of power loss
is the use of more than 3 RAID cards in your system.
If the PCI-X card cannot be powered off during a hot-plug removal operation, the attention button will turn steady-on and
the power LED will remain steady-on.
CAUTION If your slot does not power off during a hot-plug removal operation, do not open the manual retention
latch (MRL) on the OLX divider. This action causes system failure or operating system crashes.
To Next Page
Loading...
Need help?
General