Chapter 4
Installing Additional Components and Configuring
Fibre Channel (FC) Boot Configuration
79
3C 00000010 D - - 2 - Platform Console Management Driver ConPlatform
3D 00000010 B - - 2 2 Console Splitter Driver ConSplitter
3E 00000010 B - - 2 2 Console Splitter Driver ConSplitter
3F 00000010 B - - 2 2 Console Splitter Driver ConSplitter
40 00000010 B - - 2 2 Console Splitter Driver ConSplitter
4900000010D--14 -GenericDiskI/ODriver DiskIo
4A 00000010 B - - 3 10 Partition Driver(MBR/GPT/El Torito) Partition
4B 00000010 D - - 3 - FAT File System Driver Fat
4C 00000010 B X X 1 1 PCI IDE/ATAPI Bus Driver Ide
4D 00000010 ? - - - - Intel(R) PRO 100 UNDI Driver Undi
4E 00030007 B X X 3 3 Broadcom Gigabit Ethernet Driver b75Undi64
4F 00000010 D - - 3 - Simple Network Protocol Driver Snp3264
50 00000010 D - - 3 - PXE Base Code Driver PxeBc
51 00000010 D - - 3 - PXE DHCPv4 Driver PxeDhcp4
Step 2. Determine the controller handle associated with each of the two listed drivers (23 and 2A) by typing the following
command:
Shell> drvcfg -c 23
Configurable Components
Drv[23] Ctrl[29] Lang[eng]Shell> drvcfg -c 2a
Configurable Components
Drv[2A] Ctrl[2C] Lang[eng]
Step 3. Set the enumeration option for the driver 23 and controller 29 by typing the following command and selecting 1
from the enumeration policy menu:
Shell> drvcfg –s 23 29
Current policy: Enumerate all Fibre Channel devices
Please select the desired enumeration policy:
0 : Enumerate all Fibre Channel boot devices in the boot option list
1 : Enumerate all Fibre Channel devices
Q : exit with no change
Policy > 1
Drv[23] Ctrl[29] Lang[eng] - Options set. Action Required is None
Step 4. Set the enumeration option for the driver 2a and controller 2c by typing the following command and selecting 1
from the enumeration policy menu:
Shell> drvcfg –s 2a 2c
Current policy: Enumerate all Fibre Channel devices
Please select the desired enumeration policy:
To Next Page
Loading...
Need help?
General