HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 131
scrub disks
Description Analyzes specified disks to find and fix disk errors. This command acts on available disks, global
spares, and dedicated spares, but not on leftover disks. This command will fix bad-block
replacement errors, medium errors, hard errors, and SMART-count errors for the specified disks.
You can use a disk while it is being scrubbed. To check the progress of a disk scrub (DRSC) job, use
the show disks command.
When a disk scrub operation starts, event 208 is logged. When a disk scrub operation ends, event
209 is logged and specifies whether errors were found and whether user action is required.
Syntax
scrub disks disks
Parameters disks
IDs of the disks to scrub. For vdisk syntax, see Command syntax on page 22.
Example Start scrubbing disks 1.1 and 1.3:
# scrub disks 1.1,1.3
Info: Start scrubbing the disk at location - (1.1)
Info: Start scrubbing the disk at location - (1.3)
Success: Command completed successfully. (2012-10-08 11:14:11)
See also • abort scrub
• scrub vdisk
• set advanced-settings
• set job-parameters
• show disks

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures