HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 81
delete replication-set
Description Dissolves a replication set. The replication volumes associated with the replication set are converted
to master volumes and any replication snapshots associated with the replication volumes are
converted to standard snapshots. Snapshots are converted regardless of the number of snapshots
allowed by the system's license. This command must be run on the primary system.
Syntax
delete replication-set ID
Parameters ID
Name or serial number of either the replication set or its primary volume.
Example Delete replication set RS1:
# delete replication-set RS1
Info: The replication set has been deleted. (RS1)
Success: Command completed successfully. (2012-01-21 12:16:58)
Delete the replication set with primary volume MV1:
# delete replication-set MV1
Info: The replication set has been deleted. (MV1)
Success: Command completed successfully. (2012-01-21 12:17:31)
See also • show replication-sets
• show replication-volumes

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures