262 Alphabetical list of commands
show protocols
Description Shows which management services and protocols are enabled or disabled.
When the service debug protocol is enabled, remote connection is allowed, through incoming ports
only, by HP or HP’s authorized representatives for troubleshooting. Disabling the service debug
protocol removes this access.
Syntax
show protocols
Example Show the status of service and security protocols:
# show protocols
Service and Security Protocols
------------------------------
Web Browser Interface (HTTP): Enabled
Secure Web Browser Interface (HTTPS): Enabled
Command Line Interface (Telnet): Enabled
Secure Command Line Interface (SSH): Enabled
Storage Management Initiative Specification (SMI-S): Enabled
Unsecure Storage Management Initiative Specification (SMI-S 5988): Disabled
File Transfer Protocol (FTP): Disabled
Simple Network Management Protocol (SNMP): Enabled
Service Debug (Debug): Disabled
In-band SES Management (SES): Enabled
Success: Command completed successfully. (2012-01-18 15:13:23)
Basetypes • security-communications-protocols
• status
See also • set protocols