284 Alphabetical list of commands
show snap-pools
Description Shows information about snap pools owned by a specified controller or both controllers.
Syntax
show snap-pools [controller a|b|both]
Parameters controller a|b|both
Optional. Shows snap pools owned by controller A only, by controller B only, or by either controller
(both). If this parameter is omitted, all snap pools owned by either controller are shown.
Output Vdisk
Vdisk name.
Serial Number
Snap pool serial number.
Name
Snap pool name.
Size
Total size of the snap pool volume.
Free
Amount of free space available in this snap pool.
Master Volumes
Number of master volumes associated with this snap pool.
Snapshots
Number of snapshots using this snap pool.
Status
• Available: The snap pool is available for use.
• Offline: The snap pool is not available for use, as in the case where its disks are not present.
• Corrupt: The snap pool’s data integrity has been compromised; the snap pool can no longer
be used.
Threshold
Snap pool threshold level:
• Warning: The snap pool is moderately full. When this threshold is reached, an event is
generated to alert the administrator. The default is 75%.
• Error: The snap pool is nearly full and unless corrective action is taken, snapshot data loss is
probable. When this threshold is reached, an event is generated to alert the administrator and
the associated snap-pool policy is triggered. The default is 90%.
• Critical: The snap pool is 98% full and data loss is imminent. When this threshold is reached,
an event is generated to alert the administrator and the associated snap-pool policy is triggered.
%Usage
Threshold value (percent of snap pool space used) that triggers the threshold’s policy.
To Next Page
Loading...
Need help?
General
